|
Post by holden on Aug 29, 2008 15:41:14 GMT 11
Hi all, This is how I made my rear seat disconnects that only cost me $1.00. 1. Get the 2 pins out of the seat brackets. 2. Drilled 1 hole by the end of each pin for the R clips. R clip 3. Make sure it still fits (It did) 4. Glue the plastic bushes to the bracket so they dont fall out. 5. Fit it back to your Truck (This is a Isuzu MU) and now you will be able to take the rear seat out of your truck without unbolting it. thx kane
|
|
|
Post by geeves on Aug 29, 2008 16:01:42 GMT 11
Interesting mod and quite useful in a Mu where there isnt that much room. Strange noone has come up with this before. Something similar should work in the swb bighorn
|
|
|
Post by Yarno on Aug 29, 2008 18:17:41 GMT 11
I have that done but didn't think to glue the bushes in, just took me longer to put back in making sure the bushes were not crushed.
I think I will glue them in next time I put the seat in Thanks Kane.
Yarno
|
|
|
Post by holden on Sept 2, 2008 18:15:42 GMT 11
I have that done but didn't think to glue the bushes in, just took me longer to put back in making sure the bushes were not crushed. I think I will glue them in next time I put the seat in Thanks Kane. Yarno hey Yarno The gule look to have worked well it didnt take much thinking to think of it just really done it. kane
|
|