suza
Isuzu Baby
Posts: 15 
|
Post by suza on Jan 23, 2008 19:23:15 GMT 11
I am about to give my Bighorn a 50mm lift ;D and am looking into new coils, has anyone used the Maxitrac ones ? and are there any known problems with them  Going to crank up the front as well and am curious will I also need to do the Ball joint flip to get the wheel alingment back? Cheers for any help |
|
|
|
Post by geeves on Jan 23, 2008 20:15:20 GMT 11
50mm you might get away without the ball joint flip but you will need a wheel alignment anyway so you might as well have the extra travel you get from a ball joint flip at the same time.
Dont know much about the coils but the leaves have been described as a little stiff to get good travel
|
|
suza
Isuzu Baby
Posts: 15
|
Post by suza on Jan 24, 2008 6:42:43 GMT 11
Cheers
for your imput I will look into this as I really like the current flex and dont want to loss it.
Has anyone tried to adpt the rear electric sway bar disconnect for the front? just an idea I had while eating breakfast.
|
|
suza
Isuzu Baby
Posts: 15
|
Post by suza on Feb 7, 2008 14:20:00 GMT 11
Ok the parts are ordered all is looking good I just need them to arrive and the Bighorn is going up ;D, the front is getting the ball joint flipped and the torison bars wound up, the pack is getting 50mm lift coils from by Maxitrac from 4wd Stuff. Now before I go and rip into it are there any pitfalls I should know about And how far can I wined up the torsons Cheers for any help |
|
|
|
Post by geeves on Feb 7, 2008 15:53:10 GMT 11
front and back have to match and 50mm with a ball joint flip will still work ok on the front without hitting the real nasties More than this still needs more mods to work properly although 100mm can be achieved but not recomended
|
|
