|
|
Post by cooledmu on Jan 29, 2008 17:24:00 GMT 11
does anyone know what the inside diameter in mm of the 4jg2 top radaitor hose is?
|
|
roga
Isuzu Junior
Posts: 58
|
Post by roga on Jan 29, 2008 17:46:29 GMT 11
4JB1 (2.8) is 32 mm
|
|
gecko
Isuzu Junior
Posts: 92
|
Post by gecko on Jan 29, 2008 18:54:09 GMT 11
just had a look at the old hoses from my 3.1, the bottom one is 36mm inside diameter and the top one seems to be 32mm at one end by 40mm at the other, might be stretched though i dont know, repco should have them on there system, thats where i got the new ones from
|
|
JaSiN
Isuzu Junior
96 Grey Mu + Plenty of Mods + Plenty more to come!
Posts: 139
|
Post by JaSiN on Jan 30, 2008 20:43:37 GMT 11
Funny this should come up.... my top hose just died, right at the servo and just around the corner from repco! which was great! after some fun trying to explain that a MU's 4jg2 is the same as the holden 4jg2, they had no stock and a holden dealer was miles away. so i had a look at all the masses of preformed hoses and managed to eye one off, bought it took it out and hacked it to the right size, the lucky thing was it was the right size and had a section in the middle that i could use. its from a Holden Commodore VN, VG (V6) and associated Lexen. this is how it came out after removing about 20cm of hose, a little from each side.  |
|
|
|
Post by geeves on Jan 30, 2008 20:50:12 GMT 11
It looks a better fit than the original.
Now the bad news All your other hoses are just as old so when you have spare time it would be a good idea to replace the lot.
Only time my wagon went home on a towtruck was because of a blown heater hose
|
|
|
|
Post by cooledmu on Feb 10, 2008 11:27:20 GMT 11
cool i just wanted to know because i have an aftermarket water temp gauge and the sender goes inline, so i need to cut a gap in the pipe and fit it but theres a few different sizes. Is that an ally radiator you have greeves?
|
|
|
|
Post by geeves on Feb 10, 2008 17:20:36 GMT 11
thats not mine
|
|
