Help rebuilding 4jb1t

auzzie
Isuzu Baby

Posts: 16

Help rebuilding 4jb1t Nov 1, 2004 17:58:13 GMT 11

Post by auzzie on Nov 1, 2004 17:58:13 GMT 11

Hi eveybody,
Just about finished rebuilding my 4jb1t from my MU. After pulling the engine and inverting the block to undo the sump, I found a 3mm diameter ball bearing on the ground. I suspect it has something to do with the oil pump or assmbly where the oil filter does up. I have posted this elsewhere but am getting desperate. Any help appreciated.
Jason

auzzie Isuzu Baby Posts: 16	Help rebuilding 4jb1t Nov 9, 2004 9:15:02 GMT 11 Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by auzzie on Nov 9, 2004 9:15:02 GMT 11 Well just for a follow up. I pit the engine back together without the bearing and it goes great. Seems my exhaust manifold was a little loose, so engine is a little quieter now .

Benzev Isuzu Baby Posts: 43	Help rebuilding 4jb1t Nov 13, 2005 15:22:12 GMT 11 Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by Benzev on Nov 13, 2005 15:22:12 GMT 11 It didn't happen to come from a ratchet you may have used?(the 3mm ball I mean)
	A fool's lips bring him strife and his mouth invites a beating. Proverbs 18:6

spectral Isuzu Baby Posts: 32	Help rebuilding 4jb1t Nov 13, 2005 16:04:46 GMT 11 Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by spectral on Nov 13, 2005 16:04:46 GMT 11 does the oil pressure relief valve have a ball in it on the 4jb1t?

Post by auzzie on Nov 1, 2004 17:58:13 GMT 11

Post by auzzie on Nov 9, 2004 9:15:02 GMT 11

Post by Benzev on Nov 13, 2005 15:22:12 GMT 11

Post by spectral on Nov 13, 2005 16:04:46 GMT 11