|
|
Post by Jimmu on Feb 8, 2006 17:44:20 GMT 11
The powersteering is leaking on my MU. (4JB1T)
I am sure I have seen a post somewhere here about who was found to be the cheapest for changover units. But I cannot find it now.
Fulcrum want nearly $400 for a changeover unit.
Can someone point me in the right direction?
Jimmy
|
|
|
|
Post by Yarno on Feb 8, 2006 18:23:42 GMT 11
Hey Jimmy
You can have mine for $250+post it was rebuilt about 2 years ago and has proabably done less than 10000k's.... I no longer need it, comes with pitman arm.
cheers
Yarno
|
|
|
|
Post by geeves on Feb 8, 2006 21:15:21 GMT 11
You might get away with changing only the top seal. A while ago Mulover did a document on changeing this Which I was going to tidy up and put on the old site.I will get it done one day. I can send you the whole lot by email if you want. It 4k txt and 400k of jpg
|
|
|
|
Post by Graham on Feb 9, 2006 19:24:15 GMT 11
I had a hose split and loose power steering fluid, cost approx $200 but if I could have gotten the hose off myself and gone to Enzed or similar for a replacement, might have been closer to $100.
Where's yours leaking from?
|
|
|
|
Post by Jimmu on Feb 9, 2006 22:33:28 GMT 11
I might just take you up on that offer Yarno... If things keep going the way they have been there will be more of your truck on my truck than yours  To be honest I am not sure where is is leaking from. It appears to be the box thingy but now you mention it I should check a little more carefully to make sure. Geeves if you could send that to me it would be great. Jimmy. |
|
|
|
Post by Harry on Feb 10, 2006 19:16:06 GMT 11
It'll most likely be the input shaft seal.There's a shroud around it which tends to move the fluid all over the box.
Regards,Harry.
|
|
