|
|
Post by impaul on Aug 10, 2006 7:56:53 GMT 11
hi,
im after info on fitting 2wd front hubs etc onto a mu..
its a project..
i have no idea about isuzu/holden 2wd utes,but want to know if the hub assemblies bolt up just like the mu does..
id like to get some 2wd hubs to chuck on the mu for its new look..also,is the 2wd hubs 5 stud or 6 stud?
|
|
|
|
Post by geeves on Aug 10, 2006 13:42:33 GMT 11
Forget the Kingswood style hubs They are very different and you would be in sub frame changing hell. The hot rodders use these all the time so it wouldnt be impossible but a lot more time with the grinder and also a lot more questions from the certifier as this would also affect the brakes.
I think the Rodeo ones should fit but this is uncharted waters. Measure in at least 20 directions before handing over the money. For the record the stub axle assembly on the Mu is identical to the LWB bighorn includeing the angle to the tie rod.
The way the hubs are set up it wouldnt be hard to get them redrilled and restuded as 5 stud
|
|
|
|
Post by impaul on Aug 10, 2006 15:59:16 GMT 11
was meaning the rodeo...
need a brake upgrade for sure aswell.
|
|
|
|
Post by geeves on Aug 10, 2006 16:16:40 GMT 11
When will we get more clues as to what you are trying to achieve? Will it go under 10 sec for a quarter mile? Will it go under 5
|
|
|
|
Post by impaul on Aug 10, 2006 17:36:49 GMT 11
under 5 foot?hehe...was thinking along the lines of a spaceframe chassis,but who knows yet..
im being restricted at the moment by having no garage as of next week..
moving to fox glacier area..have to leave my cars in chch in storage:(
but will continue planing/researching/saving
|
|
