|
|
Post by Pissy on Jun 18, 2007 21:34:44 GMT 11
Just trying to get all my facts right before I do this. I know that a quiet a few manuals have had it done but wondered about the autos. I am mainly concerned with the Auto gear lever and 4wd selecter stick with a 2" body lift. I remember reading a long time ago that a previous auto MU owner had problems with the one or both of these after the lift. Can anyone advise me on this issue and any mods to overcome or fixes PLEASE?
Cheers
Chris
|
|
|
|
Post by muvit madness on Jun 18, 2007 22:48:45 GMT 11
hi pissy when i did my 2 1/2" lift mine being the 2.8auto nothing changed inside the cab although mine has 2 t-bars instead of 1 & a small gearstick. but i had to adjust the shift kik down rod on the left side of the box almost all the way out to accomodate the differance in the body lift. its just a nut,clip & another nut unwinding it out the ways but ensure the rod is disconected of the side of the gearbox before you jack the body up or you might damage the lever  hope this is of help? unsure about your selector stick though  regards muvit  |
|
daisy
Isuzu Junior
Posts: 90
|
Post by daisy on Jun 18, 2007 23:24:09 GMT 11
ive done a two inch body lift on my 3.1 auto easy as 8-)hardest bit is modifying
the bumper brackets O and bending the short stick (4x4 selector) with heat!
note remove lever to heat. and for the auto lever i had to adjust there is plenty
of adjustment able. droped the radiator down, i raised the fuel tank up @65mm
its tight now! just watch the wires and pipe work as she goes up.
have fun ;D
|
|
|
|
Post by Pissy on Jun 19, 2007 13:39:03 GMT 11
Thanks guys, will think about it again as I am not a mechanic or have ANY SKILLS and would have to pay someone to do the both levers, radiator drop and anything else. It could just NOT be worth it unfortunately |
|
|
|
Post by Pissy on Jul 9, 2007 13:57:54 GMT 11
ive done a two inch body lift on my 3.1 auto easy as 8-)hardest bit is modifying the bumper brackets O and bending the short stick (4x4 selector) with heat! note remove lever to heat. and for the auto lever i had to adjust there is plenty of adjustment able. droped the radiator down, i raised the fuel tank up @65mm its tight now! just watch the wires and pipe work as she goes up. have fun ;D PM sent to you Daisy Cheers |
|
daisy
Isuzu Junior
Posts: 90
|
Post by daisy on Jul 9, 2007 20:52:24 GMT 11
hey there pissy (Chris) here is a pic of the rod that you adjust to
get the auto shifter to line up and work after the lift
|
|
hope this is of help? unsure about your selector stick though 
