Altering boost

[roga]

Hi Guys,
I am sure this has been covered before but.....
When fitting the valve to alter the boost you place it between the turbo and the waste gate ??
If so there is very little room for this when you also have an inter cooler fitted so can you lengthen the line to place it in an easier place to adjust or can you put in a tee and have one side of the valve venting to atmosphere ??

Thanks for your help

[Jimmu]

Any of the above will work. The inline boost controllers work a bit better than the venting units as the boost is not being wasted.

I used slightly longer hose to hook mine up and I have seen it done with a hose right into the cabin and back to the wastegate so the boost can be altered by the driver on the fly.

Jimmy

[dasnoboarder]

What's the difference between an inline and a venting controller?

I've got a GFB device hooked up to my MU, but not properly tested yet. It has the screw which when opened, lets out air, tricking the wastegate into opening later... Sounds like a venting one.

Andy.